Bipac 7402x and FTTC

Discussion for BiPAC 7402 series: 7402, 7402G, 7402X, 7402GX, 7402NX..etc
Post Reply
andycarter
Posts: 1
Joined: Tue Oct 04, 2011 5:33 pm

Bipac 7402x and FTTC

Post by andycarter »

Hi There.
I am putting a 7402x in on a Fibre to the Cabinet line. It is replacing a Zyxel 6404 which is running in no nat mode.

I have configured the ewan port as ppoe with 3g as failover, but although i can get connected , I think the router is NATing so incoming is not being routed correctly
Looking through the config pages, when the ewan interface is set to ppoe, there isnt an option to switch NAT on or off.

am i looking in the right place?

With our other sites, using adsl, it all works fine with NAT switched off.

any ideas please?

Thanks

Andy
admin
Site Admin
Posts: 92
Joined: Mon Jul 04, 2011 2:53 pm

Re: Bipac 7402x and FTTC

Post by admin »

I think you should contact support for an updated firmware with NAT on/off option on EWAN.
Post Reply