Cannot access router after enabled Lan firewall

[edblun]

Turned in Lan firewall, now can't access router, help?
Regards
Ed

[billion_fan]

Turned in Lan firewall, now can't access router, help?
Regards
Ed

if you don't have a interface grouping setup the only option is to reset back to factory default settings (the LAN side firewall blocks access to the web gui, hence its doing its job)

Hopefully you have a back up of your config that you can restore once the reset has been performed.

Or you have a interface grouping setup, you can try accessing the device from another group eg guest wifi network that does not have the LAN side firewall enabled

[edblun]

if you don't have a interface grouping setup the only option is to reset back to factory default settings (the LAN side firewall blocks access to the web gui, hence its doing its job)

Thanks billion Fan, i did just that. fortunately not too much of a hassle to reinstall saved config file. and I'm back online again. whats the old adage "don't do networking when tired, etc"

note to self : leave lan firewall alone till remote access set...."