Port Forwarding

[billion_fan]

I'm hoping you've already hit the nail on the head, as if the default is PPPOA then I didn't change it.

That's right, you will need to delete the rules and add them again as you can't edit the 'Interface' type

[Bert0364]

Right, rushed hope checked rules and you're spot on no editing option.

Removed existing ones and went about adding new ones.

There are a set of existing Skype ones so I click Add ... and enter the following

Interface drop down - pope_eth/ppp1.1
Server Name - Custom Service
Custom Service - PlexMediaServer
Server IP Address - 192.168.1.(iMac static IP address)
Time Schedule - Always On
External Port
Start - 32400 End - 32400
Protocol - TCP
Internal Port
Start - 32400 End - 32400

Click Apply and am greeted with Invalid Session Key, please try again

Doh!

Hold the help desk, I think I may have cracked it.

I've re-input all my Virtual Server settings and disabled and then re-enabled UPnP and I can now see my Server if I disconnect my iPhone from my WiFi and simply use my 3G signal.

[billion_fan]

Right, rushed hope checked rules and you're spot on no editing option.

Removed existing ones and went about adding new ones.

There are a set of existing Skype ones so I click Add ... and enter the following

Interface drop down - pope_eth/ppp1.1
Server Name - Custom Service
Custom Service - PlexMediaServer
Server IP Address - 192.168.1.(iMac static IP address)
Time Schedule - Always On
External Port
Start - 32400 End - 32400
Protocol - TCP
Internal Port
Start - 32400 End - 32400

Click Apply and am greeted with Invalid Session Key, please try again

Doh!

Hold the help desk, I think I may have cracked it.

I've re-input all my Virtual Server settings and disabled and then re-enabled UPnP and I can now see my Server if I disconnect my iPhone from my WiFi and simply use my 3G signal.

Great news

[Bert0364]

Final check from my work PC, all good

Thanks for your help BF.