-
mouse1
- Posts: 8
- Joined: Sat Jul 25, 2015 9:40 pm
Post
by mouse1 »
mouse1 wrote:Just set up my first Billion, and I am having difficulty configuring the inbound IP filter.
Shields-up shows telnet (23) is open by default, so I added an inbound filter rule but telnet still says it is open.
There's no allow/block setting on the inbound rules
If I log an inbound rule I seem to get the return packets from outbound rules. (So it's not stateful?)
Firewall is enabled on WAN interface. Firmware is: 2.32d.dm12
I have some virtual servers set up. These seem to work.
Am I missing something?
Mouse
OK I have it. It seems that these ports are always open for router access. Best have a good password then! (Any way to close them?)
And default is block so rules have effect of allowing.
-
mouse1
- Posts: 8
- Joined: Sat Jul 25, 2015 9:40 pm
Post
by mouse1 »
mouse1 wrote:Just set up my first Billion, and I am having difficulty configuring the inbound IP filter.
Shields-up shows telnet (23) is open by default, so I added an inbound filter rule but telnet still says it is open.
There's no allow/block setting on the inbound rules
If I log an inbound rule I seem to get the return packets from outbound rules. (So it's not stateful?)
Firewall is enabled on WAN interface. Firmware is: 2.32d.dm12
I have some virtual servers set up. These seem to work.
Am I missing something?
Mouse
Sorry this was posted while I was learning ... I have replaced this by a separate post now I understand a bit more.