Help with AV200 setup

Discussions for BiPAC Homplug products: P106N, P106R2, 2073N, 2074..etc
billion_fan
Posts: 5388
Joined: Tue Jul 19, 2011 4:30 pm

Re: Help with AV200 setup

Post by billion_fan »

hectordavid92 wrote: Tue Jan 31, 2023 9:36 pm
billion_fan wrote: Tue Jan 31, 2023 3:43 pm
hectordavid92 wrote: Tue Jan 31, 2023 3:28 pm

I already tried and I could not solve it, when I try to enter the management of the device 192.168.1.254 I get a boot page where it asks me for a file with a configuration.
Not sure, with UK firmware the default IP was 192.168.1.253, I assume you tried extracting the contents of the zip file to get the .afw (which is the firmware file)

I would try again and leave it for 10 minutes after the file is uploaded.

But I must admit I never seen a recovery page on the 2073N (the AV 200 series has been discontinued more then 6 years ago, so can't confirm now)
Do you have any save of the configuration of the device? Sorry for the insistence is that I would like to solve this problem. greetings and thanks
Actually I just found one, attached is the config file I pulled from it
You do not have the required permissions to view the files attached to this post.
hectordavid92
Posts: 5
Joined: Sun Jan 29, 2023 2:08 pm

Re: Help with AV200 setup

Post by hectordavid92 »

billion_fan wrote: Wed Feb 01, 2023 12:51 pm
hectordavid92 wrote: Tue Jan 31, 2023 9:36 pm
billion_fan wrote: Tue Jan 31, 2023 3:43 pm

Not sure, with UK firmware the default IP was 192.168.1.253, I assume you tried extracting the contents of the zip file to get the .afw (which is the firmware file)

I would try again and leave it for 10 minutes after the file is uploaded.

But I must admit I never seen a recovery page on the 2073N (the AV 200 series has been discontinued more then 6 years ago, so can't confirm now)
Do you have any save of the configuration of the device? Sorry for the insistence is that I would like to solve this problem. greetings and thanks
Actually I just found one, attached is the config file I pulled from it
ok, thanks I'll try when I get home and tell him. regards
Post Reply