Interface Grouping limitation

[m-a-r-k]

I have set up a Guests Interface Group containing 2 guests 2.4g SSIDs. All appears OK when the guest SSIDs are enabled. If I disable a guest SSID for security reasons it disappears from the Interface Group and when I enable it again it appears in the Default Interface Group! That's clearly not what I want.
To make it worse, you can't edit the existing Groups, so I can't add it back to the Guests Group again without having to remove the group and set it up again!

Clearly, as in other places, the firmware designer/programmer of these web interface pages hasn't used the routers in anger.

Please make it possible for Group set ups not to be changed when SSIDs are disabled and enabled again. Or at least add an edit facility.
Thank you.

[billion_fan]

I have set up a Guests Interface Group containing 2 guests 2.4g SSIDs. All appears OK when the guest SSIDs are enabled. If I disable a guest SSID for security reasons it disappears from the Interface Group and when I enable it again it appears in the Default Interface Group! That's clearly not what I want.
To make it worse, you can't edit the existing Groups, so I can't add it back to the Guests Group again without having to remove the group and set it up again!

Clearly, as in other places, the firmware designer/programmer of these web interface pages hasn't used the routers in anger.

Please make it possible for Group set ups not to be changed when SSIDs are disabled and enabled again. Or at least add an edit facility.
Thank you.

Please post your request in the 'Suggestions and Wishlist' section found below, don't forget to add the model for the request, so our engineers can see it

viewforum.php?f=15

[m-a-r-k]

Done, thank you.