QoS setup issue on 7800DXL

[billion_fan]

eliot_uk/ITSNev I have requested the firmware, once I have I will post it.

[billion_fan]

eliot_uk/ITSNev I have requested the firmware, once I have I will post it.

Firmware for the Bipac 7800DX can be found here

http://www.billion.uk.com/esupport/inde ... x_232d_da1

[DoctorAce]

Sorry to necro this thread but just got around to trying this again. Upload (LAN to WAN) QoS seems to be working fine with this firmware on 7800DX but I can't get download (WAN to LAN) to throttle.

My settings are:

IP Version: IPv4
Application: Guest
Direction: WAN to LAN
Protocol: Any
DSCP Marking: Disable
Rate Type: Limited
Ratio: 25%
Internal IP Address: Set to guest domain, but also tried leaving blank for any
External IP Address: Blank for Any but also tried 0.0.0.1 to 255.255.255.254
Time Schedule: Always On

Any suggestions as to what I might be missing?

[billion_fan]

Sorry to necro this thread but just got around to trying this again. Upload (LAN to WAN) QoS seems to be working fine with this firmware on 7800DX but I can't get download (WAN to LAN) to throttle.

My settings are:

IP Version: IPv4
Application: Guest
Direction: WAN to LAN
Protocol: Any
DSCP Marking: Disable
Rate Type: Limited
Ratio: 25%
Internal IP Address: Set to guest domain, but also tried leaving blank for any
External IP Address: Blank for Any but also tried 0.0.0.1 to 255.255.255.254
Time Schedule: Always On

Any suggestions as to what I might be missing?

Is this for a quest wireless network?

[DoctorAce]

Yes it is, I have a guest/virtual AP set and use Interface grouping to assign the SSID for the guest wireless to a separate group name and then assign a separate DHCP address range to that group name

[billion_fan]

Yes it is, I have a guest/virtual AP set and use Interface grouping to assign the SSID for the guest wireless to a separate group name and then assign a separate DHCP address range to that group name

Can you make sure the WAN is set to the 'Grouped WAN Interfaces' as shown on the attached screen shot

[DoctorAce]

How do I do that? The available WAN interfaces box is empty

[billion_fan]

How do I do that? The available WAN interfaces box is empty

I assume because you are using ADSL/PPPOA

[DoctorAce]

Yes, that's correct - PPPOA over a BT supplied wires only ADSL

[billion_fan]

How do I do that? The available WAN interfaces box is empty

Can you submit a ticket here http://www.billion.uk.com/esupport/inde ... ets/Submit and attach a copy of your config file with the password set to 'admin' I will investigate once I get time.