Billion UK Forum

evansnp wrote:Silly question; doesn't VNC use UDP?

I think it uses TCP only, but it shouldn't matter its just proof of concept

Though a solution wasn't found I want to say how good the tech service has been, I had a member of staff remote access my computer and attempt to sort everything out for me, the conclusion 1 hour and 40 minutes later is.....

My NVR does not like my Hik Vision IP Cam (The other IP cam works fine), every possible combination was tried and every time the NVR would freeze then reboot and continue in this cycle until the hik vision feed was stopped manually.

Just very strange that the NVR would freeze and reboot as soon as the feed was activated.

Once again thanks for all your help, and hopefully a new NVR will sort the issue.

evilbane wrote:Though a solution wasn't found I want to say how good the tech service has been, I had a member of staff remote access my computer and attempt to sort everything out for me, the conclusion 1 hour and 40 minutes later is.....

My NVR does not like my Hik Vision IP Cam (The other IP cam works fine), every possible combination was tried and every time the NVR would freeze then reboot and continue in this cycle until the hik vision feed was stopped manually.

Just very strange that the NVR would freeze and reboot as soon as the feed was activated.

Once again thanks for all your help, and hopefully a new NVR will sort the issue.

Thanks for posting a update,

If you need any further assistance in the future don't hesitate to contact us

Merry Christmas and Happy New Year

I'm also having problems. I've tried all the methods described in the manual and in this forum. None have worked. I'm simply trying to forward port 80 to an internal IP. I'm going to do a factory reset and try everything again.

tnylmsmr wrote:I'm also having problems. I've tried all the methods described in the manual and in this forum. None have worked. I'm simply trying to forward port 80 to an internal IP. I'm going to do a factory reset and try everything again.

See attached screen shot example

This also doesn't work for me.

I've even tried a factory reset and still no joy it just won't open the ports!

Any advice ?

Letmein wrote:This also doesn't work for me.

I've even tried a factory reset and still no joy it just won't open the ports!

Any advice ?

The key is to make sure the correct interface is selected, also make sure the correct default gateway is set to the device that you need to port forward too