Virtual Servers over IPSEC
Posted: Wed May 17, 2017 2:36 pm
Hi everyone,
Just wanted to check with you guys regarding an issue I've been having.
Here's a summary of my setup:
Site A Network
Public: 60.x.x.100
Internal: 192.168.2.0/24
Site B Network
Public: 60.x.x.200
192.168.1.0/24
I have a VPN tunnel active between the two sites (IPSEC). It is on 24/7.
I need to have someone from the Internet (external to both sites) be able to access a server via port 443 at Site B through Site A's public IP 60.x.x.100.
What I did was to setup in the NAT section under Virtual Servers an entry so that an external request would be routed to the IP at Site B (192.168.1.20).
However, when I tried to access via the Internet Site A's public IP like this: 60.x.x.10:443, nothing happens. In fact, I don't even get a packet at Site B's router.
Is it not possible to set a Remote IP in the Virtual Server list? What options do I have if any?
Kind regards,
Armen
Just wanted to check with you guys regarding an issue I've been having.
Here's a summary of my setup:
Site A Network
Public: 60.x.x.100
Internal: 192.168.2.0/24
Site B Network
Public: 60.x.x.200
192.168.1.0/24
I have a VPN tunnel active between the two sites (IPSEC). It is on 24/7.
I need to have someone from the Internet (external to both sites) be able to access a server via port 443 at Site B through Site A's public IP 60.x.x.100.
What I did was to setup in the NAT section under Virtual Servers an entry so that an external request would be routed to the IP at Site B (192.168.1.20).
However, when I tried to access via the Internet Site A's public IP like this: 60.x.x.10:443, nothing happens. In fact, I don't even get a packet at Site B's router.
Is it not possible to set a Remote IP in the Virtual Server list? What options do I have if any?
Kind regards,
Armen