Billion UK Forum

Hi Everyone, thanks for the great forum, joined today.

Can someone advise the best option/guide to set up 6in4 using tunnelbroker.

I used to have a setup through DDWRT on an old RTN16 and it worked sweet, but switched to the amazing 7800 DX today and it all naturally looks different. Just needed some advise of where to put the different parts of the tunnel broker information into the 7800DX ipv6 tunnel details.

Hope that make sense and thanks for the help.

Did anyone ever get this sorted as I have the same issue. Thanks (didn't want to start a new thread, sorry if this is wrong).

Demo777 wrote:Did anyone ever get this sorted as I have the same issue. Thanks (didn't want to start a new thread, sorry if this is wrong).

No update yet (was reported on the 8800NL to our engineers), our engineers are looking into it, (we have requested a setup guide also)

Many thanks for the quick reply, I'll keep my eyes open for a fix/guide when it comes around.

Sorry to bump an old post, but did this ever get sorted or perhaps a guide got produced. I've been messing with the settings since the original post trying to figure it out with the view of procducing a guide, but so far I've not been able to get the right settings from Tunnel Broker into the correct place on the IPv6toIPv4 boxes.

KingTurkish wrote:Sorry to bump an old post, but did this ever get sorted or perhaps a guide got produced. I've been messing with the settings since the original post trying to figure it out with the view of procducing a guide, but so far I've not been able to get the right settings from Tunnel Broker into the correct place on the IPv6toIPv4 boxes.

Issue resolved with firmware 2.32e, attached is the setup guide.