IPv6 Autoconfig page - multiple groups

[robhorton]

Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob

[billion_fan]

Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob

I'll check with our engineers and get back to you

[robhorton]

Did you get anywhere with this?

Rob

[billion_fan]

Did you get anywhere with this?

Rob

I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted

[billion_fan]

Did you get anywhere with this?

Rob

I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted

After checking with our engineers they have stated the "IPv6 Autoconfig" only supports the br0 interface which is "Default".