Hi - just got hold of a second user 7800N and trying to set up for use on sky fibre to replace a Sagemcom fast 2504n
I have flashed firmware version 1.06h OK but when I select the MPoA protocol the username and password box disappear.
Are there some instructions somewhere I can follow
Hi -
Have made some progress since previous post.
Can now connect to internet using cable but wireless doesnt seem to be working even though it is enabled
I am using firmware version 1.06h.dt2 is this the latest and correct one ?
nexus.sixx wrote:Hi -
Have made some progress since previous post.
Can now connect to internet using cable but wireless doesnt seem to be working even though it is enabled
I am using firmware version 1.06h.dt2 is this the latest and correct one ?
thanks
Yes 1.06h.dt2 is the latest release, is the wireless LED on, on the front of the device?
When I powered the unit off and back on again the wireless light flashed on and back off but it then
stays off.
Should it be on permanently when the wireless option is enabled ?
I have tried lots of different devices and nothing can see the wireless signal
nexus.sixx wrote:When I powered the unit off and back on again the wireless light flashed on and back off but it then
stays off.
Should it be on permanently when the wireless option is enabled ?
I have tried lots of different devices and nothing can see the wireless signal
Yes the wireless LED should be on, when the wireless is working.
Hi
Sorry for what may be a stupid question in this forum.
My ISP is Sky I have ordered a 7800N and want to set up to connect straight to Sky as the sky Wi-Fi is crap.
I can see the set up help that looks pretty straight forward.
But what do I put in for username|passwork where do I get these from ?
I do have wireshark V1.12.3 and can get it to run but need to know how to get this info ?
is this the correct firmware for Sky ?
UKBillion7800NV6_1.06h.dt2.afw