Billion 8800 AXL static route help

[aharnaman]

Hi all,

Im very new to this router and need to find out how the modem/router can replicate functionality I Had when I was using a separate TG582n.

So im on FFTC so my internet comes in via ppp1.1 pppoe_0_1_0.101 PPPoE on the internet side, then the router has a LAN ip of 192.168.0.x

On the TG582n the router could appear on different ranges such as 192.68.0.x but also 192.168.1.x (all on the same lan physical lan port) and whilst I have found interface grouping, which could allow me to create the 192.168.1.x range, the hardware runs over the same cables/switches. So my understanding is that inorder for the router to provide traffic on the 192.168.1.x range, without using interface grouping, I will need to add a static route under advanced setup > routing > static route.

Am I right in thinking that to get this working id need to add

Ip verison : ipv4

destination ip/prefix would be 192.168.1.0 (ie the lan range for 192.168.1.0 - 192.168.1.254)

Interface would be LAN/br0 (as im only routing traffic for machines on 192.168.1.x range outbound to ppp1.1 pppoe_0_1_0.101 PPPoE, and the 192.168.1.x range is connected on LAN0 on the back of the router via Ethernet cable)

Im not to sure about metric or gateway however ? would the gateway be the LAN ip of the AXL on the 192.168.1.x range ?

Please do feel free to ask any questions, worse case scenario I wil draw up a visio diagram

Cheers

[aharnaman]

Ok no takers maybe a rough vizio diag will help

http://i.imgur.com/xfhjsTc.jpg

So in the diag, pcs on range 192.168.0.x should be able to go via pri or secondary internet. This is working correctly, as the billion has a 192.168.0.x address on the lan port. Wireless devices do dhcp and dns via the billion, and are separated on the ir own group.

Problem I have is that I cant see how to give the billion a 192.168.1.x ip address on the lan, as grouping only allows a lan port in 1 group. So this is why I ask if I add a static route to the billion so that traffic on the 192.168.1.x range can go out via the billion on 192.168.0.x range. I appreciate the billion may not be able to do dhcp for the 192.168.1.x range and I can offload this to a network box with no issue, I just need the ability for the billion to work across both 192.168.0.x and 192.168.1.x ranges which my cheaper TG582n did.

[aharnaman]

Ok it was a silly question and I was looking in the wrong area. Turns out I just needed to setup an IP alias