Page 1 of 1
Configuration change not sticking
Posted: Wed Aug 12, 2015 4:22 pm
by adrianchapman
I am trying to set up static IPv4 and IPv6 addresses on my 8800AXL. I can select the "static IP" box, enter the numbers, but when I change apply nothing gets changed. This repeatable and has been an annoyance for some time. I am running the latest firmware.
Re: Configuration change not sticking
Posted: Wed Aug 12, 2015 4:40 pm
by billion_fan
adrianchapman wrote:I am trying to set up static IPv4 and IPv6 addresses on my 8800AXL. I can select the "static IP" box, enter the numbers, but when I change apply nothing gets changed. This repeatable and has been an annoyance for some time. I am running the latest firmware.
Seems to work here
See attached screen shot, just tested it, and it accepted it fine, (every time I click on the edit button I see both IPv4 and IPv6 addresses added)
Maybe you can try entering my WAN IP's to see if the router accepts it (I know it won't give you a internet connection, but the test is to show that the router will let you set static IPv4/Ipv6 addresses)
Ipv4 address - 82.61.213.9
Ipv6 address - 2001:4d48:ad57:1700::/56
Re: Configuration change not sticking
Posted: Wed Aug 12, 2015 4:49 pm
by adrianchapman
I have two configurations on the router, one for adsl and one for vdsl, I am currently on a vdsl service, which is the one I can't change. Oddly, I can change the adsl configuration.
I tried your settings, same problem.
Re: Configuration change not sticking
Posted: Thu Aug 13, 2015 4:12 pm
by billion_fan
adrianchapman wrote:I have two configurations on the router, one for adsl and one for vdsl, I am currently on a vdsl service, which is the one I can't change. Oddly, I can change the adsl configuration.
I tried your settings, same problem.
Have you tried to add another PTM interface?? (leave the username and password and VLAN ID as -1, or blank)