Page 1 of 1
7800N, IPv6 and the Zen Trial
Posted: Tue Sep 29, 2015 8:32 pm
by bsdnazz
Hi,
Has any one had any luck getting a 7800N working on the Zen IPv6 trial?
I've got some trial IP addresses, have enabled IPv6 on my 7800N (currently on firmware V 1.06e) but with no joy.
Any clues or pointers out there?
Re: 7800N, IPv6 and the Zen Trial
Posted: Wed Sep 30, 2015 9:21 am
by billion_fan
bsdnazz wrote:Hi,
Has any one had any luck getting a 7800N working on the Zen IPv6 trial?
I've got some trial IP addresses, have enabled IPv6 on my 7800N (currently on firmware V 1.06e) but with no joy.
Any clues or pointers out there?
Have you enabled 'Ipv6 Autoconfig' as shown on the attached screen shot??
Re: 7800N, IPv6 and the Zen Trial
Posted: Wed Sep 30, 2015 9:04 pm
by bsdnazz
Yes, IPv6 autoconfig is set.
7800n_status.png
7800_WAN_profile.png
7800n_LAN_IPv6_Autoconfig.png
Re: 7800N, IPv6 and the Zen Trial
Posted: Wed Sep 30, 2015 9:05 pm
by bsdnazz
and...
7800N_ARP_Table.png
7800N_PC_Interfaces.png
Re: 7800N, IPv6 and the Zen Trial
Posted: Wed Sep 30, 2015 11:10 pm
by bsdnazz
Nearly there!
Having run a shed load of netsh commands to disable various IPv6 tunnel interfaces I can get IPv6 working if I use stateful configuration. If I try and use stateless autoconfiguration Windows 7 goes not get an IPv6 address. I want to use stateless to I get fixed MAC address based IPv6 addresses.
Might it be worth upgrading my firmware to 1.06h?
Re: 7800N, IPv6 and the Zen Trial
Posted: Thu Oct 01, 2015 9:19 am
by billion_fan
bsdnazz wrote:Nearly there!
Having run a shed load of netsh commands to disable various IPv6 tunnel interfaces I can get IPv6 working if I use stateful configuration. If I try and use stateless autoconfiguration Windows 7 goes not get an IPv6 address. I want to use stateless to I get fixed MAC address based IPv6 addresses.
Might it be worth upgrading my firmware to 1.06h?
Yes you can, I would suggest upgrading to 1.06h.dt2
Re: 7800N, IPv6 and the Zen Trial
Posted: Thu Oct 01, 2015 10:13 am
by billion_fan
billion_fan wrote:bsdnazz wrote:Nearly there!
Having run a shed load of netsh commands to disable various IPv6 tunnel interfaces I can get IPv6 working if I use stateful configuration. If I try and use stateless autoconfiguration Windows 7 goes not get an IPv6 address. I want to use stateless to I get fixed MAC address based IPv6 addresses.
Might it be worth upgrading my firmware to 1.06h?
Yes you can, I would suggest upgrading to 1.06h.dt2
On our Enta line, I normally setup IPv6 manually
Attached screen shots (other ISP's eg IDnet or Andrew & Arnold use the auto configuration, the later has been using the 7800N for some years now with IPv6)