Billion UK Forum

Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob

robhorton wrote:Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob

I'll check with our engineers and get back to you

Did you get anywhere with this?

Rob

robhorton wrote:Did you get anywhere with this?

Rob

I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted

billion_fan wrote:

robhorton wrote:Did you get anywhere with this?

Rob

I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted

After checking with our engineers they have stated the "IPv6 Autoconfig" only supports the br0 interface which is "Default".