Page 1 of 1
ETEC7800DXL_2.32d.dr3.afw Firmware
Posted: Fri May 01, 2015 7:09 pm
by m-a-r-k
I know this isn't mainstream but thought it ought to be addressed.
ETEC7800DXL_2.32d.dr3.afw does not generate any Security Logs.
Firmware was downloaded from this forum. Installed after rebooting with Factory Default Settings and reconfiguring from scratch.
Re: ETEC7800DXL_2.32d.dr3.afw Firmware
Posted: Tue May 05, 2015 9:49 am
by billion_fan
Seems ok here, try the following
1. Do a 'All Service Port' scan with 'Shields Up'
2. Check your 'Security Logs' again
Re: ETEC7800DXL_2.32d.dr3.afw Firmware
Posted: Tue May 05, 2015 7:25 pm
by m-a-r-k
OK, all ports are stealthed and I do get some Security Log entries from Shield's Up IP address from port 966 onwards.
I used to get a huge amount of entries in the Security Log before this ROM update - strange.
I was worried that the router was not noticing these hack attempts and letting them pass through. However my Comodo Internet Security firewall isn't logging anything either so I guess I'm OK?
Re: ETEC7800DXL_2.32d.dr3.afw Firmware
Posted: Wed May 06, 2015 9:42 am
by billion_fan
m-a-r-k wrote:OK, all ports are stealthed and I do get some Security Log entries from Shield's Up IP address from port 966 onwards.
I used to get a huge amount of entries in the Security Log before this ROM update - strange.
I was worried that the router was not noticing these hack attempts and letting them pass through. However my Comodo Internet Security firewall isn't logging anything either so I guess I'm OK?
Yep you should be fine mate
